Stitcher Feeder Operation
The Stitcher Feeder can be bolted to the infeed of most stitchers to
make them operate fully automatically. Guide boards fitted to the
stitcher conveyor accurately position filled sacks approaching the
feeder. The feeder arm enters the sack top and pulls it into a toothed
feed belt, which shapes and feeds it to the stitcher. The Stitcher
Feeder bolts directly onto some stitcher pedestals, others require
adaption plates.
Sack Specification
Most paper sacks are suitable providing the tops stand open and there is
approximately 200mm of ullage(distance from the product in the bag to
the top of the sack).
Ticket Dispenser Operation
As an addition, a Single or Double Ticket Dispenser can be bolted to the
Stitcher Feeder to automatically apply one or two tickets. The Double
Ticket Dispenser can be used to apply single tickets if required.
As standard, dispensers are fitted with a tray for fanfold tickets, but
a free running turntable for rolls of tickets can be fitted instead
should this be required.
Ticket Specification
Tickets should be made of stout paper or thin card and have an 8mm hole
punched at the joint centre. Ticket rolls must not exceed 200mm
diameter.
Ticket height can range between 30-140mm, ticket width (pitch between
perforated joints) can range between 75 - 150mm.
Speeds
The speed of the belt feeder on the Stitcher Feeder can be matched to
your conveyor a maximum throughput of 15 sacks per minute is typical.
Approximately 300mm is required between each sack.
Electrical Requirements
Standard: 415V, 50/60 Hertz 3 Phase, 6 Amp Supply. Alternatives can be
accommodated.
Air Requirements
Cool, clean, dry air at 6 bar (90 PSI) at 27Litres (1 CuFt) per cycle.
I.e. 12 cfm at 12 sacks per minute 20mm (3/4”) supply pipe minimum.
Shipping Specification
Case Size (mm); 1,200 x 1,000 x 1,400 high.
Gross Weight; 85 Kg.