Operation
The approaching sack operates the Topforms automatic cycle. Two blades
enter the sack, the leading blade accurately positions the top of the
sack and the trailing blade stretches the sack to the required width.
The sack is then fed forward into the sealer or stitcher at the same
speed as the conveyor. This action gives very precise presentation with
minimal setting up time.
Control System
Systems are supplied with a control panel containing a PLC which links
to an infeed sensor to control start/stop times. SMC and Origa
Pneumatics for reliability and long life.
Packing Speeds
The easy speed of the Topform is achieved by the blades moving with the
sack then returning at high speed to pick up the next one, up to 15
Sacks per minute are possible.
Conveyor Requirements
Works with almost any conveyor with sufficient spare length.
Sack Specification
The main requirement of the sack is that the top must remain upright and
open as the filled sack is conveyed. Guide boards are usually used to
achieve this. Normal size range is 300mm to 600mm wide (including
gusset). Sizes outside this range can usually be accommodated by small
changes to specification Length of sack is unimportant as long as
sufficient Ullage is available to allow blades to operate and the top to
form the correct shape. For plastic and difficult bags use the Total Bag
Control System.
Electrical Requirements
Standard: 110/240, 50/60 Hertz 1 Phase, 2 Amp. 24 Volt versions
available.
Air Requirements
Cool, clean, dry air at 6 bar (90 PSI. Allow 2CFM per 10 sacks per
minute.
Shipping Specification
Top Form Only: Case Size (mm); 500 x 1,000 x 800 high. Gross Weight; 100
Kg.
Top Form With Stand: Case Size (mm); 2,000 x 1,000 x 800 high. Gross
Weight; 150 Kg.